da towster vehicle side for rear mounting

Vehicle part for rear mounting
 The rear end must be at least 40mm wide on the outside and 32mm wide on the inside. Milan, Bülk, DF are definitely possible, A7 probably isn't. The rear end should also of course be able to bear sufficient loads.
 The mounting point should be approximately vertical. The drawbar should then be connected approximately horizontally.
 Assembly:
 First drill the 5.5mm holes for the screws; the outer sheet can be used as a drilling template. Fix the outer sheet to the hole pattern with the screws inserted. Then mark the center of the large hole. Remove the sheet again and drill a 32mm hole with a hole saw. If there is already a ventilation hole there: mark the 32mm hole and file it.
 Push floral wire through the screw hole. Thread the inner sheet metal onto it and pull it towards you. Align the sheet metal with your finger through the ventilation hole. Screw the outer sheet metal to the inner sheet metal provisionally. When everything fits, remove the screws one by one and screw them back in with Loctite and tighten them permanently.
 Weight: 71g